How to Test a Touch Screen for Dead Zones and Ghost Touches

📄 6 min readUpdated November 19, 2026

Open the touch screen test, drag one finger slowly across the pad, and watch for gaps in the line. Then press several fingers down at once and check each gets its own colored dot. That covers dead zones, ghost touches and multi-touch in about a minute. Here's how to read what you see, and where the test can't reach.

How do you test a touch screen for dead spots?

  1. Take off the case and screen protector if you can, and wipe the glass dry.
  2. Open the touch screen test and turn on Ghost grid. It draws a faint 40-pixel grid so you can follow straight lines.
  3. Drag one finger slowly along each grid line, left to right, then top to bottom. Keep the finger down for the whole sweep.
  4. Draw two diagonals, corner to corner, and a few slow figure-eights.
  5. Look for breaks. A healthy screen draws one unbroken glowing line under your finger.

Go slowly. A fast swipe can skip ahead between touch updates, and the gap that leaves looks a lot like a dead spot. If you see a break, go over that exact area again at half the speed. A real dead zone breaks the line in the same place every time.

The grid doesn't detect anything by itself, by the way. It's only a guide for your finger.

Why doesn't the test cover the edges of my screen?

The pad sits inside the page, with padding around it, so a strip down each side of a phone screen is never part of it. That matters, because edges and corners are where dead zones often turn up after a drop. We worked out the pad size from the page's layout:

ScreenWidth (CSS px)Pad widthUntested strip each sideWidth covered
Small Android phone360 px262 px49 px73%
iPhone 13 to 15 size390 px292 px49 px75%
Large Android phone412 px314 px49 px76%
Tablet, portrait768 px582 px93 px76%

The pad is also 420 pixels tall, which is less than a full phone screen. To cover the rest:

How do you check multi-touch?

Put two fingers down, then three, and keep adding. Each one gets a colored dot labeled T1, T2 and so on, and the counters keep score:

ReadoutWhat it countsReset by Clear trails?
Touches activeFingers on the pad right nowYes
Max simultaneousThe most fingers seen at once since the page loadedNo, reload the page
Total pointsEvery new touch since the page loaded (one per finger down, not per dot drawn)No, reload the page

The page has only six colors and labels, and it picks them from the ID the browser gives each finger, so two fingers can occasionally share a color. Count the dots, or trust the Max simultaneous counter, which counts every finger.

Spread your fingers wide. Some screens struggle to separate two fingertips that are very close, and you'll see them merge into one dot. If Max simultaneous won't climb past 2 even with fingers far apart, check the device's spec sheet before calling it faulty. Cheap tablets sometimes support only a few points.

Clear trails wipes the drawing but not the counters. Reload the page if you want Max simultaneous back at zero.

What causes ghost touches?

A ghost touch is the screen reporting a press where there isn't one. On the test, you'll see a line or dot start by itself. Common causes:

What you seeLikely causeNext step
A line stops while your finger keeps moving, always in the same spotDead zone in the digitizerRemove the case and protector, clean, retest. Repair if it stays
Lines appear where you never touchedGhost touchesUnplug the charger and retest; check for a swollen battery
Line is jagged or jumps in stepsDirt, moisture or a damaged protectorDry and clean the glass, then retest without the protector
Max simultaneous stops at 1 or 2Device limit, or a failing digitizerTry with fingers spread wide apart, then compare with the spec sheet
Nothing at all registersSoftware or a hung appRestart the device before you suspect hardware

Two quick checks before you book a repair. First, unplug the charger and test again. Some cheap chargers add electrical noise that confuses the touch layer, and the ghosting stops on battery. Second, look along the screen's edge for a gap, or lay the phone flat and see if it rocks. A swollen battery pushes on the display from behind and can cause phantom presses. If you see that, stop charging the phone and get it looked at. Our battery health guide covers the other signs, and the battery test shows the live drain.

Can you test a touch screen on a laptop?

Yes, if it's a touchscreen laptop. Use your finger on the pad just as you would on a phone. The test also accepts a mouse, but it's built for fingers, and the mouse line draws in a dark color that's hard to see on the dark theme.

A stylus such as Apple Pencil usually counts as a single touch, so it's handy for drawing very precise lines over a suspect area.

What should you test next?

A touch fault and a display fault can look alike: a dark patch that doesn't respond might be dead pixels rather than dead touch. Run the dead pixel test to check the panel itself, and the screen test for uneven brightness. Our dead vs stuck pixel guide explains what each kind of dot means.

Frequently Asked Questions

How do I test my touch screen for dead spots?

Open the touch screen test, turn on the grid, and drag one finger slowly along each line, edge to edge. A healthy screen draws an unbroken line. A dead zone breaks the line in the same place every time you go over it.

Why does the line break when I swipe fast?

Fast swipes can move further than the gap between touch updates, which leaves a straight jump in the line. Go over the same spot slowly. If the line is solid at low speed, there's no dead zone.

How many touch points should my phone support?

Check the maker's spec sheet, because the number varies and some cheap tablets support only a few. On the test, spread your fingers wide and add them one at a time. Max simultaneous shows the most the page saw at once.

What causes ghost touches on a phone?

Common causes are a dirty or damp screen, a damaged screen protector, electrical noise from a cheap charger, a cracked digitizer, or a swollen battery pressing on the display. Unplug the charger and clean the glass first, then retest.

Does the touch test check the edges of the screen?

Not fully. The drawing pad sits inside the page, so on a 390-pixel-wide phone there's a strip of about 49 pixels down each side it doesn't reach. Scroll the pad to the top and bottom, rotate to landscape, and use a full-screen app for the very edges.

Related Tools